Including Serpentine BeltsDomestic and imported cars, vans and light trucks 1998-2012, Features clear, concise removal and installation instructions, Engines are identified as "interference" or "free-wheeling",

Domestic and import vehicles 2002-2012, Reset procedures, system operation, programming procedures, battery replacement, immobilizer operation,

   Connects in-line between the spark plug and the ignition wire
   Use to quickly troubleshoot ignition system with "hands-free" operation
   Technician can visually check condition of ignition system at each cylinder
   Frequency and intensity of flash indicates whether there is an ignition system problem or a fault in the fuel delivery system

Lisle LS26250 Circuit Tester

   A quick way to troubleshoot the contemporary "coil on plug" ignition systems found on General Motors, Chrysler, Ford and import vehicles
   Flashing bulb indicates ignition or fuel delivery problem
   Quickly plugs into boot on coil then clips to ground
   Ground wire is 20" long
   Shows a duplicate view of the ignition spark so technician can visually check condition of ignition system at each cylinder Frequency and intensity of flash indicates whether there is an ignition system problem or fault in the fuel delivery system
   Clear plastic body can withstand rough use and resists automotive chemicals
   Flash can be seen in bright sunlight
   Protected by mechanical strain relief
   Connects quickly
   Technician can visually check condition of ignition system at each cylinder
   Frequency and intensity of flash indicates whether there is an ignition system problem or a fault in the fuel delivery system
   Flash can be seen in bright sunlight
   Clear plastic body can withstand rough use and resists automotive chemicals
   Protected by mechanical strain relief

   The best quality electrical circuit tester available for checking 6 and 12 volt systems
   5' of tough, flexible, heavily insulated rubber wire is retained in spring supported strain relief designed to withstand the most rugged use
   Bulb is easily replaced
   Combines all the features desired by professional technicians and do-it-yourselfers

Flexible 1.5 inch silicon pins provide easy back probing connections for DMM and Scope measurements, Great for back-probing harness connectors and automotive sensors, Flexible silicon bends for difficult areas, Connects to test leads w/removable ends,

Overall length 6-1/2", Great for picking, marking and cleaning a variety of work surfaces, Can be used to remove old gaskets and o-rings during a mechanical repair or to position wires during electrical installations, Each Probe features an extended-length aluminum body with a knurled grip and a hexagonal head to prevent rolling,

   Our most computer safe circuit tester!
   High impedance - the current draw is less than 7 milliamps
   Quickly and safely tests high and low voltages (power and ground) on all vehicle circuits, including computerized engine and body controls
   Dual color LED indicates red for power (high) and green for ground (low) on 6, 12 and 24 volt systems

18 gauge copper wire, Insulated alligator clips,

Titan TTN45229 96PC MINI BLADE FUSE ASST

   Works on high energy electronic system and small engines
   Adjustable gap 0-40,000 volts
   Includes safety shield

Gives a Visual Check of the Ignition System

   Quickly diagnose problems with all ignition systems
   Connect the tool between the spark plug and the plug wire
   Double-ended to offer a straight boot and a 90 Deg boot on one tool
   With the engine running, the tool flashes a mirror image of ignition spark

Also Indicates Polarity

   Safe for automotive computers
   Will not damage sensitive electronic components
   Draws less than 21 mA. at 12 volts DC. Operating range 3-28 volts
   The red light indicates positive polarity, green indicates negative polarity

   This tool works on many ford and other electrical connectors and terminals
   The single blades have a bevel ground onto the end for working on small wire terminals found on newer vehicles

Features an extra long wire that stretches up to 12 feet for use, then automatically retracts
   Great for use on cars, trucks, boats, trails, motorcycles, airplanes and snowmobiles
   A heavy duty ground clip with insulator is on one end of the retractable wire and a spring supported strain relief is on the other
   For 6 and 12 volt vehicles

   Quickly tests voltage up to 28 volts
   Heavy duty probe, cord, and clamp
   Probe is insulated with high-visibility shrink tubing to prevent the possibility of shorting the side of the probe to other components

18 gauge copper wire, Insulated alligator clips,

   A must for testing newer vehicles with recessed spark plugs
   Troubleshoots virtually all domestic and import cars, SUV's and trucks
   Provides information not available with OBD II code reading devices
   Shows a duplicate view of the ignition spark

Alligator Clip Set

Use with 56810 or 60610 to Easily and Securely Connect Relay Test Jumper to a Multimeter

   Can also use banana plug to pin probe adapter for use with pin probes
   Kit contains: two terminal to banana tip wires, two pin tip to banana plug adapters and one terminal to banana tip wire with jumper wire
   Jumper wire may be used between common and open to close the relay circuit for testing and has a test port to easily check voltage
   Also provides access for a clamp-on amp meter.

Automotive Fuse Holder In-Line can prevent your DMM's internal fuse from blowing, ATC Fuse Holder In-Line, Provides extra overload protection, Can prevent your DMM's internal fuse from blowing, For use with any digital multimeter,

Tough, Smooth-working Reliable Switch

   Features heavy gauge, rubber-covered coper wire
   Depress button to job or start the engine

10 MegOhm circuitry prevents damage to sensitive automotive electronics, U/L listed for safety and quality, Includes easy-to-read instructions in English, French and Spanish, Your personal home and auto electrical tester, Use to safely and accurately troubleshoot a variety of automotive and household electrical problems, Includes test lead holders for hands-free testing,

Plug in the Harness Checker to your trailer plug and easily trace each lighting function to the terminal in question, Each LED light will correspond to the circuit being energized, Also provides an easy to connect ground terminal for trailer lighting set up,

Sheffield Research STC8007 Circuit Polarity Tester

16 test ranges, 6 functions, Fuse protected, safety leads and jacks, Removable test leads, Battery included,

Test Leads with Improved Tips

Test circuits up to 28 Volts and works as jumper wire for power or ground

18 gauge copper wire, Insulated alligator clips, Magnetic back allows technician to mount test leads,

   Extra bright LED work light makes working in dark areas easier than ever
   CAT IV 1000V safety rating is safe for allapplications including industrial applications
   Green Power On indicator light tells you thevoltage detector is working properly before use
   Easy to use rear push button design
   Pocket clip allows for easy storageand retrieval from pocket
   Industry leading non-contact voltage detection technology
   Powered by (2) "AAA" Batteries (included)
   Voltage Range: 50 to 1000V AC
   Safety Category Rating: CAT IV 1000V
   AC Volts: 1000
   Scan for AC Electrical: Yes
   Non-Contact Voltage: Yes
   LED Work Light: Yes
   Indication: Audible & Visual
   Switch Type: On/Off

   Designed for testing electrical circuits and locating shorts, grounds and open circuits
   12-foot, heavy-duty, red coil cord lead
   Checks 6- and 12-volt systems
   Ergonomic slim designed clear handle
   Bright red, slim style replaceable bulb
   Positive contact molded strain relief
   Heavy-duty, stainless steel probe with insulated shaft
   Heavy-duty clip with positive soldered connection

Sheffield Research STC8002 Cordless Circuit Tester

Multiple Ground Source Connection Options

   Heavy-duty circuit tester with multiple options for connecting to a ground source
   Long, 12' cord has a quick coupler to securely connect clamp or power outlet plug. Large, stron clamp conects securely
   Power outlet plug can always be used to provide ground in the cabin
   For testing circuits up to 12 volts.

The most economic way to check electronic fuel injection (EFI) signals, Quickly and easily checks for systems of GM TBI, Bosch PFI Ford TBI, GM PFI, Geo TBI and GM SCPI, To test, just disconnect the fuel injectors, plug the Noid Lite into injector wiring harness then crank the engine, Normal voltage is indicated by flashing light which is visible from passenger compartment, Blow molded case for easy storage and transport,

Circuit current from 0 - 30 amps/48 volts, Resolution .1A (100 mA), Plug in the FUSE BUDDY and read the circuit amperage draw, Great tool for electrical troubleshooting at the fuse box,

Plug in the FUSE BUDDY and read the circuit amperage draw, Great tool for electrical troubleshooting at the fuse box,

Twistguard Test Leads

For all SUVs and light trucks

Contains 20 pin type back probes